The cut:
To state the obvious, the tousled bob will not quite work if you have long hair, so this style is specifically for those who embrace short locks, or even those who like to experiment and surprise themselves. But, Mark Fast and his hair team did take the challenge and made it work for longer hair (see the styling steps below).
If we were to look back at the Flapper era, the traditional cut was always just where the ears ended or slightly above it. It was a clear bob cut. Flapper girls never had their hair long, which also added to androgynous feel of the look.
But when we translate the look in 2012, we want to make it look as modern, glamourous and effortless as we can. Since a very short bob demands high maintenance, make this look yours by keeping your hair shoulder length or an inch below the ears.
However, if you do want to experiment with your locks this New Year, then brave the scissors and go with an above the ear cut. But keep in mind that the styling will be a little more time taking and tricky.
The tools:
To style this look effectively, you’ll need the following tools:
Tail comb brush
Wire rods (if available)
Curling tong
Flat iron
Curl enhancing cream
Working spray
Hairspray
Lots of hair pins
Styling it:
At the Mark Fast spring 2012 show, Tigi’s hair team is to be credited for creating the look on the runway. James Pecis shares his styling tips on ways to get the tousled bob at home and making it street-friendly.
With wire rods:
The styling for a textured, tousled bob works best on second-day hair. If it’s freshly washed then prep the hair with a working spray and run your fingers through it. Tigi used ‘Catwalk by TIGI Session Series Work It Hairspray’ for the runway show.
Create a side part and flip the hair on one side. Use a tail comb brush and backcomb the hair around the hairline and the parting. You need to create a cushion around the head for hairpins to grip on. Don’t backcomb around the crown.
If using wire rods (though not compulsory – see below), wrap small sections of hair in figure of eights around the wire rod. Spray some hair spray on the wire rod. Use a flat iron and set the rods in place. This will give a flat wave in the hair and adhere to the 1920s look. Do it all over the outer layer of your hair.
Leave the wire in for about 20 minutes. On removing the rods, use your fingers to soften and break the shape of the curls.
If you have long hair, take the ends of the hair and secure it underneath with bobby pins. This will create a U-shaped bob with very clean lines.
Spray some hairspray and set the curls in place. The team used ‘Catwalk by TIGI Session Series Finishing Hairspray’ for this particular look.
Pull a few loose pieces out to make the look more distressed and sexy. Finish off with some shine spray, if required.
However, if you’re using a curling tong to create the 20s tousled bob, then follow the steps below.
Prep the hair by following steps 1 and 2 above.
Curl relatively large chunks of hair strands on medium heat.
When the hair has come down to room temperature, use a paddle brush to comb out the curls.
Take a flat iron and flatten the area around the hairline by pressing the hair on medium heat. Don’t run your iron over the curls; it’ll loose its shape. Spray some hairspray and set the curls in place.
Finish off with some shine spray, if required.
No comments:
Post a Comment